Manual for GE Refrigerator Model GNE25JYKHFFS

The GE GNE25JYKHFFS is a 25 cubic foot French Door Refrigerator featuring advanced temperature management, a built-in water and ice dispenser, adjustable glass shelves, humidity-controlled crispers, a full-width freezer drawer, and energy-efficient LED lighting. It includes smart connectivity options, various cooling modes, and diagnostic alerts. Below are key sections covering safety, features, installation, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation & Setup 3. First-Time Use 4. Specifications 5. Controls and Settings 6. Using the Refrigerator 7. Using the Freezer 8. Water & Ice System 9. Care & Cleaning 10. Energy Saving Tips 11. Troubleshooting

Features at a Glance

Key components: French doors with internal water dispenser, adjustable temperature zones, freezer drawer, ice maker, control panel, water filter, and LED interior lighting.

FeatureDescription
French Door DesignProvides easy access to fresh food compartment
Internal Water/Ice DispenserDispenses filtered water and ice through the door
Adjustable Glass ShelvesCan be repositioned for flexible storage
Humidity-Controlled CrispersPreserve fruits and vegetables longer
Full-Width Freezer DrawerSlide-out drawer for organized freezer storage
LED Interior LightingEnergy-efficient, bright illumination
Temperature ControlsSeparate controls for fridge and freezer
Door AlarmAlerts if door is left open
Water Filter IndicatorLight reminds when to replace filter
Power CordStandard 120V plug

Installation & Setup

Unpack and inspect contents. Position refrigerator in desired location with proper clearance.

  1. Remove all packaging materials and tape.
  2. Ensure unit is level using adjustable front feet.
  3. Connect to water line (for ice/water dispenser): Shut off water supply, connect tubing to inlet valve.
  4. Plug into a dedicated 120V AC outlet.
  5. Allow refrigerator to stand upright for 2 hours before powering on.

WARNING! Refrigerator is heavy; use two people for movement. Ensure water connections are tight to prevent leaks.

First-Time Use

After installation, power on the refrigerator and configure initial settings.

  1. Set temperatures: Press TEMP buttons to set refrigerator to 37°F (3°C) and freezer to 0°F (-18°C).
  2. Allow 24 hours for temperatures to stabilize.
  3. Install water filter: Twist out old filter (if present), insert new filter, run water to purge air.
  4. Enable ice maker: Lift the wire arm to start ice production.
  5. Load food items, avoiding blocking air vents.

CAUTION! Do not overload shelves. Keep ventilation spaces clear around the unit.

Specifications

Controls and Settings

Control panel located inside on upper right wall. Buttons: TEMP (fridge/freezer), LIGHT, FILTER RESET, ALARM, LOCK.

Temperature Settings: Range: Fridge 34°F to 46°F (1°C to 8°C), Freezer -5°F to 5°F (-21°C to -15°C).

Special Modes: Quick Cool (rapidly cools fridge), Quick Freeze (rapidly freezes), Sabbath Mode (disables lights/alarms).

Filter Reset: Press and hold FILTER RESET for 3 seconds after replacing filter.

Door Alarm: Sounds if door is open >5 minutes; press ALARM to silence.

Using the Refrigerator

Organize food for optimal cooling and efficiency.

  1. Adjust shelves as needed by lifting and repositioning.
  2. Use crispers for fruits/vegetables; adjust humidity slider.
  3. Store dairy and meats on lower shelves (coldest area).
  4. Do not block air vents at rear.
  5. Use door bins for condiments, drinks.

Tip: Allow hot food to cool before placing inside to reduce energy use.

Using the Freezer

Freezer drawer includes ice bucket and storage baskets.

  1. Pull drawer open smoothly; it may be heavy when full.
  2. Use baskets for organizing frozen items.
  3. For long-term storage, use airtight containers or freezer bags.
  4. Do not overload; leave space for air circulation.
  5. If ice bucket is full, ice maker will automatically stop.

WARNING! Do not use sharp objects to remove ice. Keep children away from ice dispenser mechanism.

Water & Ice System

Dispenses filtered water and ice through the internal dispenser.

  1. To get water: Press a glass against the paddle inside the door.
  2. To get ice: Press glass against ice dispenser paddle (select cubed or crushed if equipped).
  3. Replace water filter every 6 months or when indicator light comes on.
  4. If no water/ice, check water supply, filter, and ensure ice maker arm is up.
  5. Clean dispenser area with damp cloth only.

Note: First ice production may take 24 hours. Discard first few batches.

Care & Cleaning

Unplug before cleaning interior. Use mild soap and water; never abrasive cleaners.

  1. Interior: Remove shelves and drawers; wash with warm soapy water.
  2. Exterior: Clean with soft cloth and stainless steel cleaner (if applicable).
  3. Condenser coils: Vacuum every 6-12 months (located at back or bottom).
  4. Door seals: Wipe clean to ensure proper seal.
  5. Defrosting: Automatic; no manual defrost needed.

CAUTION! Do not use harsh chemicals, steam, or water spray on controls.

Energy Saving Tips

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/controlsCheck power cord; ensure unit is plugged in; verify temperature settings.
Water dispenser not workingFilter/supplyReplace water filter; ensure water supply valve is open; check for kinks in line.
Ice maker not producing iceArm position/temperatureEnsure ice maker arm is down; freezer must be at 0°F or below.
Excessive frost in freezerDoor sealCheck door seal for gaps; ensure door closes fully.
Unusual noisesLeveling/fanEnsure refrigerator is level; check for items touching fan at rear.
Water leaking insideDrain clogClear defrost drain tube (located at back of fridge interior).

Reset: Unplug for 5 minutes, then plug back in to reset control board.

Service: 1-800-GE-CARES (1-800-432-2737); www.geappliances.com

Manual for GE Refrigerator Model GNE25JYKHFFS © - All Rights Reserved 2025