Manual for GE Refrigerator Model GFE28GYNIFS

The GE GFE28GYNIFS is a 28 cubic foot French Door Refrigerator with external water and ice dispenser, fingerprint-resistant stainless steel finish, TwinChill evaporators for independent cooling zones, Turbo Cool settings, adjustable gallon door bins, spill-proof glass shelves, LED lighting, and advanced water filtration. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: French doors with external dispenser, adjustable interior shelves and bins, TwinChill cooling system, water filter, ice maker, and electronic controls.

Installation

Unpack and inspect contents. Ensure proper location with adequate clearance.

1. Position refrigerator: Allow 1-inch clearance at back and sides, 2-inch top clearance for ventilation.
2. Level the unit: Adjust front leveling legs so doors close properly and unit is stable.
3. Connect water line: Shut off water supply; connect approved ¼-inch copper or braided supply line to water valve.
4. Plug into dedicated 120V AC outlet.
5. Turn on water supply and check for leaks.

WARNING! Refrigerator is heavy; use two people to move. Ensure floor can support weight.

First-Time Setup

After installation, allow 24 hours for temperatures to stabilize.

1. Power on: Plug in; interior lights should turn on when doors open.
2. Set temperatures: Press TEMP pads to set refrigerator to 37°F and freezer to 0°F.
3. Activate ice maker: Lift ice maker arm to ON position; discard first batch of ice (about 24 hours).
4. Reset filter indicator: Hold FILTER RESET button for 3 seconds after installing new filter.
5. Enable Turbo Cool/Freeze if needed for rapid cooling after loading groceries.

CAUTION! Do not overload shelves. Allow air circulation inside compartments.

Specifications

• Model: GFE28GYNIFS
• Capacity: 28 cubic feet total (19.7 cu ft refrigerator, 8.3 cu ft freezer)
• Doors: French doors with bottom freezer drawer
• Finish: Fingerprint-resistant stainless steel
• Water Filter: RPWFE or MWF (check compatibility)
• Ice Production: Up to 4.5 lbs per day
• Energy Star: Yes
• Power Source: 120V AC, 60Hz, 15-amp dedicated circuit
• Dimensions (HxWxD): 70" x 36" x 34.5" (with doors open and handles)

Controls and Settings

Control panel located inside on upper right refrigerator wall.

Buttons: TEMP (fridge/freezer), TURBO COOL, TURBO FREEZE, FILTER RESET, LOCK (dispenser lock).

Temperature Settings: Fridge 34°F to 46°F; Freezer -5°F to 5°F. Turbo Modes: Press TURBO COOL or TURBO FREEZE for rapid cooling; automatically turns off after 6 hours or when target temp reached. Filter Indicator: Flashes when filter needs replacement; reset after changing filter. Dispenser Lock: Press and hold LOCK 3 seconds to disable dispenser pads.

Using the Dispenser

External dispenser provides water, cubed ice, and crushed ice.

1. Select type: Press WATER, CUBED ICE, or CRUSHED ICE pad.
2. Dispense: Press glass against pad or hold pad for continuous flow.
3. Adjust ice size: Crushed ice setting produces smaller ice particles.
4. Child lock: Enable to prevent accidental activation.

Tip: Run water for 3 minutes after filter replacement to clear air from system.

Storage & Organization

Optimize storage with adjustable components.

1. Adjust shelves: Lift front of shelf and slide out to reposition or remove for cleaning.
2. Door bins: Lift up to remove; can be repositioned to accommodate tall items.
3. Crisper drawers: Control humidity with vents; use for fruits and vegetables.
4. Freezer baskets: Slide out for access to items in back.
5. Meat drawer: Dedicated drawer with lower temperature setting for meats.

WARNING! Do not place hot food directly into refrigerator; allow to cool first.

Care & Cleaning

Unplug before cleaning interior. Use mild soap and water; avoid abrasive cleaners.

Exterior: Wipe with damp cloth; use stainless steel cleaner for fingerprints. Interior: Remove shelves and bins; wash with warm soapy water. Dispenser: Wipe with soft cloth; clean ice bin monthly. Condenser coils: Vacuum every 6-12 months (located at back or bottom front).

CAUTION! Do not use sharp objects to remove ice. Never use hot water on frozen surfaces.

Filter Replacement

Replace water filter every 6 months or when indicator light flashes.

1. Locate filter: Inside refrigerator, upper left corner.
2. Turn old filter counterclockwise and pull straight out.
3. Insert new filter (remove protective caps); align arrows and turn clockwise until it stops.
4. Run water dispenser for 3 minutes to flush.
5. Press and hold FILTER RESET button for 3 seconds to reset indicator.

Note: Use only GE RPWFE or approved replacement filters.

Regulatory Information

UL Listed; complies with NSF/ANSI standards for materials. Energy Star certified. For safety, this appliance must be properly grounded. Copyright © GE Appliances, a Haier company. For support, visit www.geappliances.com or contact 1-800-432-2737.

Troubleshooting

Reset: Unplug for 5 minutes, then plug back in to reset electronic controls.

Service: 1-800-432-2737; www.geappliances.com